Installing TOPODRONE laser scanner on DJI M200

To install the TOPODRONE laser scanner on your DJI M200, you will need the following components included in the package:  

 

 TOPODRONE laser scanner; 

 Mounting bracket and mating part; 

 A set of mounting screws; 

 Alcohol wipe; 

 Power adapter and Helix antenna. 

 

 

 

 

 

 

 Step 1 : Using a Hex 1.5 screwdriver, remove the 2 screws on the bottom of the DJI M200 drone. 

 

 

 

 Step 2: Wipe the sides of the DJI M200 with an alcohol wipe. 

 

 

 

 Step 3 : Peel off the protective films of the 3M adhesive tape and install the TOPODRONE laser scanner's U-mount. 

 

 

 

 

 

 Step 4 : Screw in the 2 M2x6 screws included in the kit using a Hex 1.5 screwdriver  

 

 

 

 Step 5 : Firmly press the U-mount on both sides where the double-sided 3M tape is attached. 

 

 

 

 Step 6 . Screw the 4 screws of the M3x10 mount mating part tightly onto the TOPODRONE laser scanner using a HEX 2 screwdriver.  

 

 

 

 

 

 Step 7 : Place the TOPODRONE laser scanner on the U-mount as shown in the photo. 

 

 

 

 Step 8 : Fasten the TOPODRONE laser scanner with the screws as shown in the photo. 

 

 

 

 Step 9 : Plug the TOPODRONE laser scanner's power adapter into the          Sky-Port connector. 

 

 

 

 

 

 Step 10 . Connect the Lemo 4 pin power cable to the TOPODRONE LiDAR. 

 

 

 

 Step 11 . Connect the antenna connector to the TOPODRONE LiDAR. 

 

 

 

 Step 12 . Screw the Helix antenna on tightly.