Skip to main content

Installing TOPODRONE laser scanner on DJI M200

To install the TOPODRONE laser scanner on your DJI M200, you will need the following components included in the package: 

  1. TOPODRONE laser scanner;
  2. Mounting bracket and mating part;
  3. A set of mounting screws;
  4. Alcohol wipe;
  5. Power adapter and Helix antenna.


Step 1: Using a Hex 1.5 screwdriver, remove the 2 screws on the bottom of the DJI M200 drone.


Step 2: Wipe the sides of the DJI M200 with an alcohol wipe.


Step 3: Peel off the protective films of the 3M adhesive tape and install the TOPODRONE laser scanner's U-mount.


Step 4: Screw in the 2 M2x6 screws included in the kit using a Hex 1.5 screwdriver 


Step 5: Firmly press the U-mount on both sides where the double-sided 3M tape is attached.


Step 6. Screw the 4 screws of the M3x10 mount mating part tightly onto the TOPODRONE laser scanner using a HEX 2 screwdriver. 


Step 7: Place the TOPODRONE laser scanner on the U-mount as shown in the photo.


Step 8: Fasten the TOPODRONE laser scanner with the screws as shown in the photo.


Step 9: Plug the TOPODRONE laser scanner's power adapter into the          Sky-Port connector.


Step 10. Connect the Lemo 4 pin power cable to the TOPODRONE LiDAR.


Step 11. Connect the antenna connector to the TOPODRONE LiDAR.


Step 12. Screw the Helix antenna on tightly.

No Comments
Back to top